Description

The IS210AEDBH3A is a board component created by General Electric for the Mark VI system.Part of the Speedtronic line, the Mark VI is a platform for the management of gas and steam turbines.The Mark VI, like other Speedtronic systems, controls speed, temperature, load, acceleration, and start-up characteristics of the turbine system.The system includes an HMI or operator interface with dynamic graphics, alarm displays, and point control display for maintenance purposes. The IS210AEDBH3A functions as a Bridge Interface board.The board has four individual sections that are very similar to each other.Three of these sections are placed side by side on the bottom of the board and one is located along the top of the board.Each section is topped by a transformer, an oscillating chip, and a 3-position plug. TheIS210AEDBH3A has a single right-angled cable connector located on the edge of the board.This is marked P1. The board has four 3-position plugs, four 6-pin male vertical pin connectors, four 10-pin male vertical pin connectors, one 8-pin male vertical pin connector, and two 2-pin header connectors. TheIS210AEDBH3A is populated by resistors, usually made of metal film, diodes, capacitors, transistors, and integrated circuits.There are over 180 integrated circuits. The board is drilled around the edge several times, and also has factory-made drill marks within the body of the board.The board is marked with codes like FA/01 and 94V-0. More information about the board uses, rack location, diagnostics, and installation procedures may be found within GE publications like manuals and user guides.