Description

The IS205SVMAG2A is a Voltage Monitor auxiliary component created by GE for the Mark VI system.The board is responsible for shaft voltage and current monitoring, which must be done to ensure there is no voltage build-up across the oil film of bearings.The Mark VI is a turbine management platform designed with centralized control. The Central Control Module of the MKVI connects to termination boards that bring inputs into the module.This data can be accessed via a non-essential operator interface running a Windows OS. The IS205SVMAG2A is a very small board component.The board has a ten-pin connector located along one short edge.This connector allows the board to be soldered to a motherboard.It is drilled in both of its upper corners to allow for secondary screw mounting to a motherboard component for extra support. The IS205SVMAG2A has markings like ttm4-10, 94v-0, and FA/00.The board has three diodes, twelve resistors, and five capacitors.The board also has a resistor network array, which is a configuration of several resistors within a single component.These are often used as voltage dividers. The board has a single integrated circuit and one transistor marked STA614 B3NA80. More information about the IS205SVMAG2A board and its component setup can be accessed through manufacturer publications.Handling procedures can also be found in these manuals. AX Control treats Mark VI boards as static sensitive during storage and during shipment.You will receive your board wrapped in anti-static film. We recommend unboxing your part using a grounding strap.