Description

The IS200IGPAG2A is a GE component made for the Mark VI system.The Mark VI is one of the many systems in the Speedtronic series for gas and steam turbine management.These systems have been in use since the Mark I was first released in the late 1960s, and have remained in use until the current time.The Mark VI and Mark VIe were the last two of these systems to be produced by GE. The Mark VI includes Ethernet communications and a central control module that maintains the majority of turbine monitoring, control, and protection. The IS200IGPAG2A is built with four LED (light emitting diode) components.Two of these are located on each short side of the board, side-by-side. Each LED faces outward.It is important to note that the two LEDs on the right side of the board are almost the only components on that side of the board.The right side of the board also has a single 9-pin header connector, as well as several terminal connectors. The right side of the board also has outlines for multiple components, but the components do not actually appear on the board. The IS200IGPAG2A is built with a single inductor coil.The board has several heat sink components. It has four high-voltage electrolytic capacitors, as well as capacitors made of polyester vinyl and ceramic capacitors.The board uses metal film resistors of various size and resistance. The board has few integrated circuits. Technical support for the IS200IGPAG2A was provided by General Electric.Installation procedures for this PCB may be found in user guides or manuals.