DS3815PCLA1D1D
DS3815PCLA1D1D GE DRIVE SYSTEMS TURBINE CTRL MODULE
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3815PCLA1D1D
DS3815PCLA1D1D GE DRIVE SYSTEMS TURBINE CTRL MODULE
- 5.00 (1)
- Click a star to rate this product
Availability:
In Stock Ships In 3-5 Days
Description
The DS3815PCLA1D1D is a printed circuit board by GE designed as a component for the Mark IV system. The Mark IV, which was created for steam or gas turbine management, replaces earlier Speedtronic systems (MKI/MKII) with an improved interface and more application flexibility. The Mark IV is designed with multiple microcomputer systems that monitor the turbines twenty-four hours a day; these backups improve reliability and decrease the turbine outage rate (compared to older systems.)
The DS3815PCLA1D1D is built with a total of five board connectors. This includes two Augat connectors, two 218A4637P1 right-angled male connectors, and one 218A4553-1 A/mp 533002-1 connector.It has two test points that are labeled TST and COM. The board is built with three light emitting diodes, including one amber LED (IMOK) and two red LEDs.
The DS3815PCLA1D1D has over sixty circuits populating the board.This includes 8-bit high-speed CMOS static RAM chips with fast access time and low power standby and low power operation. Access time is 150ns. It also has hex inverting gates, buffers/line drivers employed as memory-address drivers, clock drivers, and bus-oriented transmitters/receivers, and two-input positive-NAND Schmitt triggers with high noise immunity.
The DS3815PCLA1D1D is built with eighteen jumper switches. It has five resistor network arrays. The board is factory drilled and alignment marked. Two extractor clips are installed. These nylon clips give an advantage during extraction by providing the technician with a lever point to help pull the board from its location. They also provide a handle so the technician does not have to touch the board during installation or extraction.
The DS3815PCLA1D1D had technical support provided by GE. This includes all end-user publications like data sheets and manuals.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.