DS3800NGTA1E1D
GE DRIVE SYSTEMS GENERATOR CONTROL BOARD DS3800NGTA1E1D
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3800NGTA1E1D
GE DRIVE SYSTEMS GENERATOR CONTROL BOARD DS3800NGTA1E1D
- 4.00 (2)
- Click a star to rate this product
Availability:
In Stock Ships In 3-5 Days
Description
The DS3800NGTA1E1D is a PCB (printed circuit board) from GE manufactured as part of their Mark IV system. The Mark IV, which was designed for gas/steam turbine management, can be used for water, air and fuel emissions monitoring. It can also automate some procedures necessary in the running of turbine systems, such as start-up and cool down.
The DS3800NGTA1E1D is designed to function as a general test signal board. It has two communication connectors attached to the board, one on its left edge (218A4553-1A/mp 533002-1,) and one toward the right. The latter communicates with an optional auxiliary board which sits above four nylon pins connected to the DS3800NGTA1E1D.
The DS3800NGTA1E1D is marked for alignment, marked '6BA04,' and is also marked with the GE stamp. Extractors are installed in each right corner. Extractor clips can be used as levers to help technicians pull boards from tight locations. They also act as handles, allowing technicians to install the boards without touching delicate circuitry.
The DS3800NGTA1E1D is built with five TP test points, three resistor network arrays, three trim potentiometers, two potentiometers, one toggle switch, and four LEDs (three red and one amber.) Resistors tend to be ceramic covered metal film.
The DS3800NGTA1E1D is built with twenty-five integrated circuits. This includes hex inverters, quad 2-input positive AND gates, and dual retriggerable one-shots.
GE provided all technical support for the DS3800NGTA1E1D, including datasheets and manuals. These publications may be the best resources for information on installation or maintenance. Please follow all safety precautions.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.