DS3800HPLA1B1D
GE SPEEDTRONIC MARK 4 PANEL INTERFACE DS3800HPLA1B1D
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3800HPLA1B1D
GE SPEEDTRONIC MARK 4 PANEL INTERFACE DS3800HPLA1B1D
- 5.00 (1)
- Click a star to rate this product
Availability:
In Stock Ships In 3-5 Days
Description
The GE Panel Interface Board DS3800HPLA1B1D is designed for quick installation in the drive. The board features 1 hole in each corner. The board can be secured with screws. The board is populated with 1 40-pin connector embedded on the board. The GE Panel Interface Board DS3800HPLA1B1D daughter card also is populated with 3 red indicator LEDs. The board is also populated with 2 sockets for electrically erasable programmable read-only memory (EEPROM) modules, 7 jumpers, and 2 trimmer resistors.
The GE Panel Interface Board DS3800HPLA1B1D daughter card also is populated with wire terminals. An installer can connect a wire between 2 or more wire terminals. The installer can also install a resistor or capacitor between 2 wire terminals. To connect a wire, first loosen the screws on top of the wire terminals. Then, wrap the ends of a wire around the screws and tighten them so they are secure. Use a wire that does not have excessive slack between the terminals. Multiple wires with excessive slack can block the free flow of air. Fresh air entering the drive will flow through the drive and carry away the air that is heated by the components in the drive.
2 trimmer resistors are located on the outside edges of the board. They can be adjusted to raise or lower the resistance supplied by the component. This is useful if the technician has conferred with an engineer who has determined that a new resistance is required. Use a small screwdriver to adjust the trimmer resistor.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.