DS3800DMEA
GE DRIVE SYSTEMS MARK 4 ENERGY TURBINE DS3800DMEA
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3800DMEA
GE DRIVE SYSTEMS MARK 4 ENERGY TURBINE DS3800DMEA
- 4.50 (2)
- Click a star to rate this product
Availability:
In Stock Ships In 3-5 Days
Description
The GE DS3800DMEA is a printed circuit board (PCB) designed to fit into their Mark IV Speedtronic series, which was designed for steam and gas turbine control. The Mark IV can be used for air, fuel and emissions control, for shutdown and cooldown procedures, and can also protect against unsafe operating conditions.
The DS3800DMEA has the following specs:
-
factory drilled. There is one hole in each corner, plus one extra in the top left and bottom left corners.
-
50-pin male connector (218A4637P5) located in the middle of the right side of the board
-
eighteen jumper switches. These are in a line down the center of the board and are interspersed with nine TP rings.
-
eleven TP rings. Two test points are in the bottom left corner. The other nine are in the center of the board.
-
one switch, bottom left corner
-
eight light emitting diodes (LEDs) on the left side of the board. These are labeled tach loss, OS, OV, IOC, IOL, Field loss, Alarm, and Moving.
-
fourteen adjustable resistors (round.) These have 10-point hash marks. They are marked from 0 to 100. These resistors are in two parallel lines center-left of the board. The first line of resistors is labeled top to bottom: IE Cal, Min fld, IR comp, %M/D, Tol Adj, Overvolts, and Slo Spd. The second line is labeled top to bottom: field loss, IA Cal, CMPD, IOC Adj, CEMF Cal, Spd Adj, and OverSpd.
-
eight screw terminals
-
eight diodes
-
twenty-one metal film resistors of assorted values
GE provided technical support for the DS3800DMEA. Refer to their manual and data sheets for installation guidelines and safety protocols for this product.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.