DS3800DBIB1
DS3800DBIB1 GE DRIVE SYSTEMS GAS TURBINE INTERFACE CARD
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3800DBIB1
DS3800DBIB1 GE DRIVE SYSTEMS GAS TURBINE INTERFACE CARD
- 5.00 (1)
- Click a star to rate this product
Availability:
In Stock Ships Today
Description
The DS3800DBIB1 manufactured by GE is a small printed circuit board (PCB) designed as a component of a Speedtronic Mark IV system. The Mark IV system was designed to be modular and affordable with built-in redundancies between chipsets. This allows for the expected occasional electronics failure within a module without the failure of the turbine system as a whole, as control of the system is shifted as needed until repairs can be made to a failing part. The Speedtronic Mark IV can be used for emissions, air or fuel control, shutdown procedures, or cool-down procedures. The DS3800DB1B1 card is designed to be used as an interface board.
The DS3800DBIB1 is an auxiliary daughterboard designed to plug into a larger PCB. It has four connectors for that use embedded in the board, numbered 1 through 4. It has also been drilled out at the factory with one hole at each corner of the board for another mounting option. The DS3800DBIB1 has a total of ten 5-banded resistors and six CR capacitors mounted on its board. There is also on polypropylene capacitor. This is marked C100 and is rated 708A1, M/E 200V 1.0+10%. There is a blue potentiometer (3069P-1 103 10K,) rated 10K Ohm, located on the bottom edge of the board.
AxControl recommends referring to the original manufacturer's data sheet and/or manual before attempting installation or maintenance of the DS3800DBIB1. Please follow all safety and installation procedures recommended by the original manufacturer to avoid damage to electronics or personal injury.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.