Description

The IS200ITBAG1AAA is a circuit board component designed by General Electric as part of the Mark VI system.The Mark VI is part of the Speedtronic line of gas and steam turbine management, which has been under development by GE since the 1960s.The Mark VI is built with a primary Control Module that takes care of most of the control, protection, and monitoring for the turbine. It also has a large variety of boards designed for interface to unique actuators and sensors.These direct interfaces reduce potential failure points in most critical areas and allow for reduced long-term maintenance and overall improved running reliability. The IS200ITBAG1AAA is a long, narrow board.It is drilled in all four corners. Two of the corners are designed as conduction sensors and are labeled as E1 and E2.These openings are ringed with metal. The board has three male plugs, including two two-position vertical plugs and one five-position vertical plug.The board has three female plugs, which are placed side-by-side on the rear edge of the board. This includes a 16-position plug, a 20-position plug, and a 24-position plug. The only other components located on the surface of the IS200ITBAG1AAA are three terminal strips.One terminal strip has fifteen positions. Each position is labeled. The other two strips have thirty positions each.Numbers alternate between the two strips so even numbers are placed on the rear board and odd numbers are placed on the forward board.Each position is labeled. The board is marked with the board number, with the GE logo, and with the code 6BA02.”