DS3800NHVD1D1B
GENERAL ELECTRIC GENERATOR REGULATOR BOARD DS3800NHVD1D1B
Contact
Us!
Warranty: 3 Year Warranty
Manuals & Datasheets: Request via Email
DS3800NHVD1D1B
GENERAL ELECTRIC GENERATOR REGULATOR BOARD DS3800NHVD1D1B
- 5.00 (1)
- Click a star to rate this product
Availability:
In Stock Ships In 3-5 Days
Description
The DS3800NHVD1D1B, which was developed by GE as a high voltage card, is a component for their Mark IV series. This series, which is used for steam/gas turbine management, can be used to automate certain processes for more consistent control (startup, shutdown, cool down.) It can also be used for air, fuel, and water emissions monitoring.
The DS3800NHVD1D1B has been milled with three oval cutouts. These are placed parallel to each other. The board is also drilled in sixteen locations along its edge. It is marked for alignment along one edge.
The DS3800NHVD1D1B has one multi-pin (vertical) male connector and three 4-pin headers.The headers are placed along the board's top edge.
The DS3800NHVD1D1B is built with three transformers (218A4499 P2 C1,) three red LEDs, and two connector points.
Resistors on the DS3800NHVD1D1B tend to be carbon composite wire wound, but some ceramic covered metal film resistors are used. The most notable of the CCR resistors would be the six CGN-33 52 Ω 5% 20W Ni 1350W placed along the bottom half of the board. These are interspersed with Sprague paper in oil 196P104910 capacitors, which are attached to the board using screw-mounted clamps. The board also uses smaller capacitors and resistors.
It is worth noting the DS3800NHVD1D1B utilizes surface wiring in three locations. Intertwined black and white wires connect PTH labeled "1Wht" "2Wht" "1Blk" "2Blk" etc.
All technical support for the DS3800NHVD1D1B--including datasheets and manuals--was provided by GE. These publications can be used for reference material for installation and maintenance of this equipment.
Purchase
Please give us a call or send us an email for pricing on New Surplus and Reconditioned replacements that we have in our inventory. Our lead times are short, stock is excellent, and pricing is competitive. We hope to be your go-to supplier for all GE Turbine replacement boards and controls.
Exchange
We conveniently offer an exchange program that allows you to recycle your old board and receive an up-front discount on a replacement. Please ask about our exchange credit program if you have a defective board to exchange with the purchase of a new or reconditioned replacement. We ask that the defective board is sent in within 30 days of the purchase.
Repair
We offer repair on most GE Turbine boards we sell. Although we usually have replacements available, we recognize that customers may prefer to have their board repaired. Our repair program allows us to offer a lower cost alternative to replacement.